 |
| click to enlarge |
if you want to remove the AR(air restrictor) you have to open it up.Its alright if you already attached the stock and the priming handle because you can take the priming handle by using the claw side of the hammer and prying it open,but you have to put two cloth on the CS-6 body and the priming handle so it doesn't scratch the gun.The gun might break if you apply too much force on the gun and hammer.
 |
| click to enlarge |
 |
| click to enlarge |
You see the green oval?Thats the THANG you have to take out(REMINDER:BEFORE YOU REMOVE ANY PARTS IN THE NERF GUN IT'S BEST IF YOU TAKE A PICTURE OF THE INTERNALS SO YOU CAN REMEMBER WHAT TO PUT IN WHERE)
 |
| click to enlarge |
This is split into three parts,Above,Middle and Below.As you can see Above is just the barrel(NOTE: GREEN IS BARREL,ORANGE IS AR,WHITE IS THE PIZZA TABLE THAT HOLDS YOUR DARTS AND RED IS SCREWDRIVER).If you look at Middle you can see the AR and the Below you can see the AR and the screwdriver.To take the AR out you have to take a long screwdriver to fit in the barrel and lightly take a hammer and smash the whole thing...NAH!JUST KIDDIN! you just have to lightly tap the butt of the screwdriver with the hammer until the AR comes out OR you can heat up the screwdriver on a candle or gas stove and melt the AR out of the gun,its very fast but its really messy
 |
| click to enlarge |
The picture above shows the air pump,as you can see one of them has white stuff at the end of the pump.That white stuff is rubber padding,yes you need rubber padding for the end of the air pump because if you shoot your modded blaster without the rubber padding you will hear a loud cracking sound and that sound is the sound of your blaster breaking.Once the AR is removed the air no longer slow down the air pump to cushion it on impact,thats why you need the rubber padding,to silence the cracking sound and reduce the chance of your blaster from breaking
And now you know How It's Made...NAH I KIDD
